Connecting To A Compressed Air Source - Parkside PDRS 27 A1 Originalbetriebsanleitung

Connecting to a compressed air source

NOTE
► Before connecting the compressed air source,
–
the correct working pressure (6.3 bar) must be fully
reached, and
–
make sure that the trigger is in the upper position.
► Use only connection hoses with an internal diameter of at least
9 mm.
► Use only filtered, lubricated and regulated compressed air.
♦ Screw the connector nipple
in delivery state). Tighten the connection with a pair of pliers.
♦ Attach the tool to a compressor by connecting the connector
nipple with the supply hose of the compressed air source.
CAUTION!
► Ensure that the compressed air hose is firmly attached. A loose
hose can thrash about uncontrollably causing grave danger.
Likewise, ensure the firm seat of the two screw connections
between the coupling piece and the appliance.
♦ The compressed air source must be equipped with a pressure
reducer so that you can regulate the air pressure.
PDRS 27 A1
into the air inlet
GB │ MT
(Pre-assembled
│
87 ■