Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Maintenance and care
6.
When the line is wound to the end hook both line ends into
respective notch of spool for retaining tentatively the line
while leaving line ends approximately 10 cm beyond notch.
7.
Put spool into housing with the marked side visible.
8.
Pull out the line from housing. (A) Remove the line from "re-
spective notch for tentative line retention" and (B) pass the
line through "groove of respective eyelet".
9.
Fit cover and housing together. (C) Align "slot mark for use-
ful life" with "groove of eyelet" and (D) press pawls of hous-
ing into respective window of cover until the pawls are firmly
fitted into the windows.
Make sure each outer periphery of pawls of housing
spreads almost fully up to the outer periphery of respec-
tive window of cover. If they are loosely fitted and the cut-
ting head is turned, cover or inside components can fly off
which is dangerous.
25
DANGER
Werbung
Kapitel
Inhaltsverzeichnis
