ported on both sides, both in the vicinity
of the cut and at the edge.
f Be particularly careful when carrying
out a „plunge cut" into an existing
wall or an area you can't see into.
The plunging cutting wheel may hit
gas or water pipes, electrical cables or
other objects and cause kick back.
2 – Safety instructions relat
ing specifically to the
equipment
CAUTION! A spindle lock is
located on the upper side of the
unit. Never press the spindle lock
while the grinding body is rotating.
CAUTION! Only use reinforced
grinding disks and cup wheels.
Handling, transportation and storage
of grinding discs:
Grinding discs are fragile and sensitive
to impacts and bumps. For this reason,
special care must be taken:
• Neverdropdiscsandavoidsudden
impact.
• Donotusedroppedordamageddiscs.
• Avoidvibrationsorbumpsduring
work.
• Avoiddamagestotheholderhole.
• Avoidputtingloadsontothediscsur-
face.
• Storegrindingdiscseitherflator
upright, dry, frost-free and at a con-
stant medium temperature.
MW-5455260-Bedien-1909.indd 61
• Storegrindingdiscsintheoriginal
packaging or in special containers
and on shelves.
• Beforechangingthetoolorcarrying
out maintenance work, pull out the
power plug and wait until motor and
spindle have come to rest.
• Donotpressthespindlelockuntil
motor and spindle have come to rest.
• Donotusecuttingdiskswhichexceed
the maximum diameter stated.
• Whenfixingaccessorytoolstothe
machine, note the correct direction of
rotation of machine and accessory.
• Thepermittedrotationspeedofthe
accessory tool must not be less than
the idling speed of the machine.
• Ifnecessary,wearhand,eyeandear
protection.
• Switchthemachineonimmediately
before contact with workpiece.
• Neverlaythemachineasidewhenit
is still running.
• Secureworkpiecewithclampsetc.
• Neverusecuttingdisksforrough
grinding.
• Alwaysstoreandhandlegrinding
disks carefully in accordance with the
manufacturer's directions.
• Checkdisksbeforeusingthem.Never
use chipped, cracked or otherwise
damaged products.
61
04.10.19 10:42