Lock Function; Maintenance - Velleman WT4406 Bedienungsanleitung

6. Setting the Alarm
• Slide the switch (5) to ALM SET. The ALARM sign will appear on the display.
• Press the HR or MIN button to set the desired alarm time.
• Slide the switch (6) to ALM ON.
• Slide the switch (6) to SNOOZE to activate the snooze alarm.

7. Lock Function

After setting the time and alarm time, slide the switch (5) to LOCK to protect the set time and alarm time against
unnecessary changes caused by touching the buttons.
8. Using the Snooze Alarm
Slide the switch (6) to SNOOZE.
Once the alarm starts to ring, you can activate the snooze by pressing the SNOOZE/LIGHT button (2). The alarm will
stop for 5 minutes before ringing again. To stop the alarm completely, slide the ALARM switch (6) to OFF. Alarm
duration is 1 minute.
9. Time and Temperature Readout
Press the 12HR/24HR button (7) to choose the desired time readout. In 12HR format, PM appears indicating PM
hours.
Press the °C/°F button (8) to choose the desired temperature readout.
10. Backlight
Press SNOOZE/LIGHT to activate the backlight for approximately 3 seconds. Frequent use of this function will shorten
the life of your batteries.

11. Maintenance

Use a soft cloth moistened with mild detergent to clean the device. Do not use abrasives or solvents on the device. Do
not drop the device on a hard surface. Do not use it outdoors and shield it from direct sunlight.
12. Technical Specifications
Power Supply
Digits
Dimensions
The information in this manual is subject to change without prior notice.
WT4406
appears on the display. The alarm function is now activated.
appears on the display. The snooze function is activated.
2 x 1.5V AAA batteries (not incl.)
18 x 8mm
77 x 72 x 38mm
- 2 - VELLEMAN