Setting Up; Electric Connection; Switching Off; Operation - Beko HM130520 Gebrauchsanweisung

EN

If you do not use your appliance for a few
days, it is not advisable to switch it off. If you
do not use it for a longer period, please
proceed as follows:
- unplug the appliance;
- empty the appliance;
- defrost it and clean it;
- leave the door open to avoid the formation of
unpleasant smells.

If the supply cord is damaged, it must be
replaced by the manufacturer, its service
agent or similarly qualified persons in order to
avoid a hazard.

If your appliance has a lock, keep it locked
and store the key in a safe place, out of the
reach of children. If you are discarding an
appliance with lock, make sure that, is made
ineffective. This is very important so as to
avoid children being trapped inside, which
may cause their loss of life.

Setting up

This appliance was designed to operate at an
ambient temperature between +10°C and
+40°C. If the ambient temperature is above
+40°C, inside the appliance the temperature
can increase.
Set up the appliance far from any source of
heat and fire. Placing it in a warm room, the
direct exposure to sunbeams or near a heat
source (heaters, cookers, ovens), will
increase the energy consumption and shorten
the product life.
 Please observe the following minimun
distances:
 100 cm from the cookers working with
coal or oil;
 150 cm from the electric and gas
cookers.
 Ensure the free circulation of the air around
the appliance, by observing the distances
shown in Item 2.
Assemble on the condenser (in the rear side)
the supplied spacers (Item 3).

Place the appliance in a perfectly even, dry
and well ventilated place.
Assemble the supplied accessories.

Electric connection

Your appliance is intended to operate at a
single-phase voltage of 230V/50 Hz. Before
plugging in the appliance, please make sure
that the parameters of the mains in your house
(voltage, current type, frequency) comply to the
operation parameters of the appliance.
 The information concerning the supply
voltage and the absorbed power is given on the
marking label placed in the back side of the
appliance.

The electric installation must comply with the
law requirements.

The earthing of the appliance is
compulsory. The manufacturer has no
responsibility for any damage to persons,
animals or goods which may arise from the
failure to observe the specified conditions.
 The appliance is endowed with a supply cord
and a plug (European type, marked 10/16A)
with double earthing contact for safety. If the
socket is not the same type with the plug,
please ask a specialised electrician to change
it.
 Do not use extension pieces or multiple
adapters.
 Please keep a distance of min. 25 cm from
any furniture „suspended" above the appliance.
This clearance will also be kept in case of a
niche or of another construction element.

The appliance is not built to be included into
the furniture.

Please fit the supplied accessories.

Switching off

The switching off must be possible by taking the
plug out of the socket or by means of a mains
two-poles switch placed before the socket.

Operation

Before putting into operation, clean the inside of
the appliance (see chapter „Cleaning").
After finishing this operation please plug in the
appliance and switch on.
The green and red LEDs in the signalling block
must light.
Leave the appliance work for about 2 hours
without putting food inside it.
3
Instruction for use