Topcom Warranty; Warranty Period - Topcom BABYVIEWER 4400 Bedienungsanleitung

Babyviewer 4400
Possible
Problem
cause
The 'out of range' Baby unit is not
alarm is audible switched on
The parent unit and
baby unit are too
far apart
The parent unit The volume setting
does not reproduce of the parent unit
the sounds picked may be too low.
up by the baby unit
The microphone
sensitivity of the
baby unit may be
set too low.
Limited range and The range of the
interference during equipment
transmission depends on the
surroundings.
Steel structures
and concrete walls
can impair
transmission.
The equipment The parent unit and
emits a high- baby unit are too
pitched whistle close together
11.14 Reset
To reset the unit back to the factory settings:
To reset the parent unit:
– Press the menu button. The
22
setting menu is displayed.
– Press the + button until the reset
19
symbol is highlighted.
– Press the OK button .
17
– Press the + or - button
19
– Press the OK symbol is blinking,
press the OK button
17
the reset.
– If you want to leave the menu without
reset, select the exit icon.
– Press the OK button
17
– Press the menu button
22
To reset the baby unit:
– Press the volume up button
red/green. When the reset is finished the LED will turn
green continously.
12 EC conformity declaration
TOPCOM EUROPE NV hereby declares that this device is in
compliance with the essential requirements and other relevant
provisions of Directive 1999/5/EC.
The declaration of conformity can be found at:
http://www.tristar.eu/Klantenservice/Downloadcenter
Solution
Switch on the baby
unit
Reduce the
distance between
the parent unit and
the baby unit
Increase the
volume setting of
the parent unit
Check the VOX
sensitivity and the
volume setting of
the parent unit and
increase if
necessary.
Avoid obstacles as
much as possible.
Increase the
distance to at least
2 metres
.
21
to confirm
to confirm.
2 times to leave the menu.
until the LED is flashing
10 4

13 Topcom warranty

13.1

Warranty period

The Topcom units have a 24-month warranty period. The
warranty period starts on the day the new unit is purchased. There
is no warranty on standard or rechargeable batteries (AA/AAA
type). Consumable or defects causing a negligible effect on
operation or value of the equipment are not covered. The warranty
has to be proven by presentation of the original or copy of the
purchase receipt, on which the date of purchase and the unit-
model are indicated.
13.2 LCD defect policy
Despite the highest possible standards, the intricate
manufacturing of liquid crystal display (LCD) screens may still
produce slight visual imperfections. However, there will be
provided a warranty service for your Babyviewer 4500 LCD
screen if there are:
– 3 bright dots or 5 dark dots or 8 bright and/or dark dots in total; or
– 2 adjacent bright dots or 2 adjacent dark dots; or
– 3 bright and/or dark dots inside an area of 15mm diameter
These TFT LCD screen warranty conditions are offered by the
LCD manufacturers. Therefore, at its option, the
product will be repaired or replaced.
Please note: A bright dot is a white or sub-pixel that is always on.
A dark dot is a black or sub-pixel that is always off.
®
7