Spare Parts; Safety Instructions; Operator's Responsibility; Intended Use - Dentaurum Polyclav Gebrauchsanweisung

2.3. Copyright
These Instructions for use are copyright protected. Written approval from the
manufacturer is required if you wish to hand these Instructions for use to a third party
in whatever form – including in parts – or if you wish to use or pass on content thereof,
unless this is for internal use only.

2.4. Spare parts

Using the wrong or defective spare parts may impair the safety of the vessel or lead to
damage, malfunction or total failure.

3. Safety instructions

This symbol indicates direct danger to the life or health of the user. Disregarding
this warning may involve a serious risk to health.
This symbol indicates important safety instructions. Disregarding this warning
may cause damage to the unit and / or other property.

3.1. Operator's responsibility

The Polyclav pressure vessel is for commercial use only. The operator of the Polyclav
®
pressure vessel is therefore subject to the statutory obligations for occupational health
and safety. The operator must ensure that all employees who use the Polyclav
vessel have read and understood the Instructions for use. The Polyclav
may only be used by trained personnel.

3.2. Intended use

The Polyclav pressure vessel is designed and constructed exclusively for polymerization
®
of cold-curing polymers.
The Polyclav pressure vessel is made of stainless steel and is suitable for polymerizing
®
cold-curing polymers with homogeneous and non-porous results. It is possible to
maintain the required temperature in the Polyclav
plate (REF 070-900-00) or induction heating plate (REF 070-030-00).
The Polyclav pressure vessel fulfils the EU Pressure Equipment Directive 97 / 23 / EC and
®
the German Pressure Device Regulations (Druckgeräteverordnung, 14. GSGV), category I
(Annex no. 1).
12
pressure vessel by using our heating
®
®
pressure
®
pressure vessel
®