Initial Startup; Operation; Storage - Kärcher WBS 3 Originalbetriebsanleitung

Initial startup

Insert batteries
Note
 Use two AA 1.5 V batteries.
 Do not use different batteries.
 Do not short the poles.
For information on the operating time with full battery charge,
see chapter Technical data.
1. Open the battery cover.
Illustration B
2. Insert the batteries, paying attention to the correct align-
ment of the poles.
3. Close the battery cover.
Connection to the water line
1. Attach the garden hose to the device connection with a
commercially available quick coupling.
Illustration C
2. Connect the garden hose to the water line.
3. Open the water tap fully.

Operation

CAUTION
Spray jet
Eye injuries and hearing damage
Do not direct the spray jet at eyes or ears.
1. Press the power switch.
Operation with point jet
The point jet is suitable for the precise cleaning of superficial
dirt spots.
1. Push the power switch to position 1.
Illustration D
Operating with the rotating spray jet
The rotating spray jet is suitable for quick cleaning of slightly
soiled surfaces.
1. Push the power switch to position 2.
Illustration E
Interrupting operation
1. Release the power switch.
The spray jet stops.
1. Release the power switch.
2. Close the water tap.
3. Actuate the power switch until no more water is emitted.
4. Release the power switch.
5. Disconnect the device from the water supply.
6. Remove the batteries from the device.
ATTENTION
Leaking batteries
Risk of corrosion
Remove the batteries from the device.
ATTENTION
Danger of frost
Incompletely emptied devices can be destroyed by frost.
Empty the device completely.
Protect the device from frost.
1. Take the device out of operation (see chapter Ending op-
eration).
English
Ending operation

Storage

Frost protection
13