Specifications - Alto Professional iPA Bedienungsanleitung

SPECIFICATIONS

Transducer Low:
Transducer High:
Output Power:
Frequency Range:
Frequency Response:
Max SPL @ 1m:
Nominal Horn Coverage:
Active Crossover:
Connectors:
External Controls:
Input Control:
Cabinet:
Mounting:
Protections:
Power supply:
Dimensions (H x W x D):
Weight (speaker only):
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE
FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2)
THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY
CAUSE UNDESIRED OPERATION.
10" woofer with 1.5" voice coil
1" titanium diaphragm compression driver
200 W Continuous (135 W LF + 65 W HF)
400 W Peak (270 W LF + 130 W HF)
51 Hz – 20 kHz (@ -10 dB)
52 Hz – 20 kHz (+3 dB)
123 dB Continuous
126 dB Peak
80/100° H x 60° V nominal (-6 dB)
2.5 kHz
1 Mic/Line XLR -1/4" combo inputs
1 stereo pair of RCA inputs
1 XLR mix output
Input volume, dock volume, power switch with LED indicator,
signal/peak LED indicator, contour switch, output mode switch
-∞ to +50 dB (Line/Mic)
-∞ to +10 dB (RCA)
-∞ to +10 dB (Dock)
Trapezoidal with floor monitor capability; injection-molded polypropylene
enclosure with perforated steel grille
Integrated pole socket (36 mm diameter)
1 handle
Over-excursion, thermal, driver, DSP-based
100 VAC, 110-120 VAC, 220-240 VAC; 50/60 Hz
Inrush current at initial switch-on: 0 A
Inrush current after power supply interruption: 2.20 A
20.2" x 13" x 11.4" (513 mm x 330 mm x 290 mm)
26.6 lbs (12.1 kg)
www.altoprofessional.com
MANUAL VERSION 1.3