Installation With A Three-Point Seat Belt - JANE EXO Handbuch

2e Insert the support leg accessory until it
clicks into place.
2f Adjust the height of the support leg so that
it rests on the floor of the vehicle.
2g To remove the Support leg accessory press
the buttons under the footrest and pull out-
wards.

3 Installation with a three-point seat belt.

3a Place the EXO seat in the most reclined po-
sition (see 6, adjusting the backrest). Pass the
three-point seat belt clasp between the base
and the seat (15) and fasten it.
3b Slide the shoulder strap of the vehicle seat
belt through the clip (16) on the top part of the
seat, only the one on the side opposite to the
buckle. Close the clip.
3c Press the EXO against the seat and manually
42
To remove the seat when using ISOfix:
2h Release the fasteners sliding both unlocking
buttons (13) inwards. The lights on the front
panel (11c) will light up in red. The signals on
the fasteners will turn red.
2i Remove the seat. You can store the ISOfix
fasteners by pulling the front lever (12) and
pressing the fasteners inside the base.
tighten the vehicle seat belt.
3d Pass the strap through the red ring (17) of
the seat.