Solución De Problemas - Canon Ci C24 MFP Bedienungsanleitung

20 Ci C24/C40 MFP USER INSTRUCTIONS
No display on scanner.
Scanner will not operate.
Scanner does not take the
document.
Scanner keeps running after failing
to load the document.
Scanner is running slow.
Document scans at an angle.
Scanned image is white.
ENG
Lines parallel to leading edge are
broken near start of image.
Lines parallel to leading edge are
broken all through image.
Diagonal lines in image broken.
Image background color changes
across image.
Transparencies scan/copy badly.
Black, green or gray lines down the
image.
Random color patches in image.
Scanner pauses during scan / copy. Slow down the scanner.
No hay imagen en el escáner.
ESP
El escáner no funciona.
Power is not ON.
Cable not connected to power socket or to low voltage adapter.
Low voltage power plug not inserted into scanner.
Fuse may need replacing. Call for support.
Low voltage adapter may be defective. Call for support.
Do not power-on the scanner with a loaded document. Remove
document and start again.
Load document more quickly into scanner until a resistance is felt.
Hold in place until scanner takes the document.
Move document away from scanner until motor stops. Try loading
again. See previous item.
Select faster speed in software.
USB cable is too long. Max. 78" (2m).
Computer is too slow or needs file maintenance.
Image detail is set too high.
Check for obstruction inside scanner or rotate the document.
Check document larger than A4 and/or use magnetic guide.
Avoid very smooth documents.
Ensure document is loaded facing the sensors.
Lower scan speed or increase image detail setting.
Check for obstruction or bad document leading edge. Turn
document.
Run automatic stitch from Utilities program.
Check the paper weight setting is correct for document.
Run automatic stitch from Utilities program.
Run full normalisation from Utilities program.
Switch OFF scanner and clean the roller.
Switch OFF the scanner. Check lenses for contamination and clean
ONLY if necessary. Run normalisation from Utilities.
Run full normalisation from Utilities program.
Increase image detail setting.
Check computer specification is correct.
SOLUCIÓN DE PROBLEMAS
No hay suministro de energía eléctrica.
Cable no conectado a la toma de corriente o a un adaptador de
baja tensión.
La clavija de toma de corriente de baja tensión no está introducida
en el escáner.
Quizás sea necesario sustituir el fusible. Llame al servicio de
asistencia técnica.
El adaptador de baja tensión puede estar defectuoso. Llame al
servicio de asistencia técnica.
No encienda el escáner habiendo cargado un documento. Retire el
documento y empiece de nuevo.
P/N: 88D010A Colortrac Ltd © 2012
6
6
6
3
6
6
6
8
8
6