Input Selector - NAD L 40 Bedienungsanleitung

GB
IN TUNER MODE:
PRESET
Press PRESET up or down to select one of the
FM Preset stations. Each time these buttons are
pressed, the display panel will show the preset num-
ber and the preset frequency, or station name if it is
an RDS radio.
NOTE:
The RDS feature is totally dependent on the capa-
bility of the radio broadcast. Many stations do not yet
broadcast in RDS. NAD can make no guarantee
about local RDS availability. Please check with your
local broadcasters.
On the remote control there are also a SKIP/PRE-
SET buttons. These buttons perform the same
actions as the buttons on the front panel.

8. INPUT SELECTOR

The INPUT SELECTOR control actually operates
two buttons either side of the control, indicated by lit-
tle raised pips. To operate, press either one of the
desired pips.
Pressing the right side of the control causes L 40 to
scroll through its inputs in the following sequence:
CD > Aux > Tape > Tuner > CD.
Pressing the left side of the control causes the L 40
to scroll through its inputs in reversed order:
CD > Tuner > Tape > Aux > CD.
Press either button repeatedly until the desired
source is shown in the display.
REMOTE CONTROL:
The remote control has separate buttons for each
input. Press the corresponding button for the desired
input.
9. REPEAT
This button engages an endless-repeat cycle.
Press the REPEAT button once to select the
REPEAT 1 mode, which repeats only the current
track over and over again.
Pressing the REPEAT button once again selects
the REPEAT ALL mode, in which mode the entire
disc or a pre-programmed selection of tracks is
played from beginning to end, over and over again.
Press the Repeat button a third time to cancel the
repeat cycle and return to normal operation.
10. STORE
IN CD MODE:
The L 40 CD receiver allows you to pre-program
the CD player to skip the tracks of a CD you do not
want to hear (negative programming). Programming
the CD player can only be done with a CD present in
the tray and in Stop mode.
To engage Program mode, press STORE. Use the
SKIP/PRESET buttons to choose the track you do
not want to play; the track number is blinking in the
display. Press CANCEL (No. 12) to confirm the track
you wish to delete. The display confirms this first
track cancellation by indicating "P--01".
NAD
8
Select the next track you want to skip and press
CANCEL again; the display indicates "P--02". repeat
this procedure until all the track you do not want to
play have been selected.
After you have selected all tracks you do not wish
to play, press the PLAY button to start playback of all
remaining tracks. During Program Play, "PROGRAM"
will be lit in the display.
NOTE:
Pressing STOP/OPEN (No. 5) will delete a program
and disengage the Program mode. Changing to a dif-
ferent source (such as tuner, for example) will also
delete any program and disengage Program mode.
IN TUNER MODE:
The L 40 CD Receiver allows you to store up to 30
radio stations (presets) in its memory.
To store a station as a preset, first tune to the
desired radio station using the SEARCH/TUNE con-
trol buttons (No. 17).
Press the STORE button. The display panel will
show the lowest available preset number for approxi-
mately 6 seconds.
Within these 6 seconds, press STORE again to
store the station under this preset number.
If you wish to use a different preset number, use
the SKIP/PRESET control buttons (No. 7) to select
the desired number before pressing store again. Note
that only empty preset numbers will be shown; should
you wish to use a preset number already in use, you
will have to clear that first (refer to section CANCEL,
No. 12)
NOTE:
Apart from the radio station itself, the L 40 will also
remember if Mono (No. 16) was selected. This is par-
ticularly useful if you wish to listen frequently to a
weak station. The procedure is the same as
described above, but after having selected the
desired preset number, select MONO (No.16);
"STEREO" will extinguish in the display. Press
STORE.
NOTE:
The Store mode will automatically cancel itself after
approximately 5 seconds if no other buttons are
pressed.
11. RANDOM
IN CD MODE:
Pressing the RANDOM button will engage play-
back of all tracks on the CD in a random order. Press
RANDOM either from the Stop or the Play mode and
the L 40 will start to play the tracks on the CD in ran-
dom order until all the tracks have been played.
Press the RANDOM button again to cancel random
play and return the L 40 to the normal Play mode.