Start-Up And Use; Starting The Appliance; Using The Display - Scholtes rcb 31 aae i Gebrauchsanleitung

Start-up and use

Starting the appliance

GB
!
( see Installation ).
! Before connecting the appliance, clean the
compartments and accessories well with lukewarm
water and bicarbonate.
! The appliance comes with a motor protection control
system which makes the compressor start
approximately 8 minutes after being switched on. The
compressor also starts each time the power supply is
cut off whether voluntarily or involuntarily (blackout).
Once you have plugged the appliance into the mains
socket, make sure the display is on (the FREEZER
COMPARTMENT knob must not be on Off).
When you turn the appliance on (by turning the
FREEZER and APPLIANCE ON/OFF Knob to the
required freezer compartment operating temperature),
we recommend you enable the SUPER FREEZE
function to speed up the cooling process inside the
compartment; when the latter has reached the optimal
temperature, the function will be disabled and you may
place the frozen foods inside the freezer.
When you turn the refrigerator compartment on (by
turning REFRIGERATOR OPERATION Knob to the
required refrigerator compartment operating
temperature), we recommend you enable the SUPER
COOL function to speed up the cooling process inside
the compartment: after a few hours, you may place
food inside the refrigerator.
It is recognizable due to the presence of the mechanism
on the top part of the refrigerator compartment ( see
diagram ).
The "Dynamic Bio Conservation" System maintains a
constant fridge temperature to keep food fresher for
longer and will quickly restore the temperature to the
correct level, even if the door is opened frequently: the
18
System.
B
A
blown air (A) is cooled when it comes into contact with
the cold wall, whereas the hotter air (B) is sucked up
( see diagram ).
The back wall may be covered in frost or droplets of
water, depending on whether the compressor is in
operation or whether it is paused.

Using the display

Setting the temperature
If the compartment concerned is switched off, the word
OFF will appear on the relative indication space on the
display (REFRIGERATOR COMPARTMENT setting and
FREEZER COMPARTMENT setting). If the compartment is
switched on, then the temperatures set at that time will
appear. To change them, turn the relative knob directly
(REFRIGERATOR OPERATION Knob and FREEZER
OPERATION and APPLIANCE ON/OFF Knob).
The refrigerator compartment can be set to between
+2°C and +8°C, while the freezer compartment can be
set to a temperature of between -18°C and -26°C. The
temperature in both cases can be increased or
decreased by 1°C at a time.
When the HOLIDAY function is enabled, temperature
regulations cannot be made, but the appliance
automatically sets itself to the best setting for the
situation: +12°C for the refrigerator compartment (if
enabled) and -18°C for the freezer compartment.
Function status
Function symbol during normal operation
Function selected (outline flashing)
Function enabled (outline on)
Press the MODE button as many times as necessary for
the red outline of the function you wish to act on to light
up: this indicates that the function has been selected
and is ready to be enabled or disabled. Now you can
enable or disable the selected function using the
SELECT button.
! If you do not confirm your selection by pressing the
SELECT button within five seconds of the last action
performed on the display, the latter shall go back to
displaying the function previously set and indicate that
no new modification has been made.