Operation; Switching On / Off / Selecting The Temperature; Temperature Levels; Automatic Switch-Off - Silvercrest SHK 100 B2 Bedienungsanleitung Und Sicherheitshinweise

Please note that, for safety reasons, the heating
pad must not be used after a fault and must be
returned to the service address indicated.

Operation

NOTE: the heating pad may smell of plastic the
first time you use it, but this will disappear after a
short period of time.
Switching on / off / Selecting
the temperature
To use the device, first connect the control unit
to the heating pad by plugging the plug-in
connector and the plug for the control unit
2
together (see Fig. B).
3
Switching on:
Set the control unit
switch on the heating pad.
Switching off:
Set Level 0 on the control
heating pad off.
Selecting the temperature:
Set the highest temperature level (Level 6)
shortly before use. This heats the pad fastest.
If you are going to use the device for a number
of hours, set it to the middle temperature setting
(setting 3).

Temperature levels

Set the required temperature level on the con-
trol (see Fig. A).
1
Setting 0: off
Settings 1+2: minimum heat
Settings 3+4: medium heat
Settings 5+6: maximum heat
Safety system / Operation / Cleaning and care
to a setting 1–6 to
1
to switch the
1
Automatic switch-off
NOTE: The heating pad switches itself off automat-
ically after about 90 minutes. The LED indicator on
the control unit
1
First select position "0" and after approx.
5 seconds select the required temperature level
to switch the heating pad back on.
Switch the heating pad off (Level "0") or take
the mains plug out of the socket if you do not
wish to use the heating pad after automatic
switch-off.

Cleaning and care

1
Use the heating pad with the textile cover to
prevent soiling or damage to the heating pad
(particularly if using essential oils and creams).
FROM ELECTRIC SHOCK! Before
cleaning the heating pad, always
pull the mains plug out of the mains socket and
separate the plug-in connector
plug for the control unit
DANGER OF ELECTRIC SHOCK!
Do not reconnect the control
the heating pad until the
plug-in connector
completely dry. There is otherwise a risk of an
electric shock.
DANGER OF ELECTRIC SHOCK!
DANGER OF MATERIAL
DAMAGE! Do not under any
circumstances switch the heating pad on to dry
help it dry.
Do not use chemical cleaners or scouring
agents to clean the heating pad or the control
unit . Otherwise the heating pad could be
1
damaged.
Never immerse the control unit
other liquids. Otherwise you might damage it.
Do not hang the heating pad up to dry with pegs
or similar. The heating pad may otherwise be
damaged.
Use a dry, fluff-free cloth to clean and care for
the heating pad and the control unit
shows "A".
RISK TO LIFE
from the
2
(see Fig. B).
3
and the heating pad are
2
in water or
1
1
to
1
.
GB 9