Ariete 2462 Bedienungsanleitung Seite 10

EN
To SUCK:
- Insert the extremity of the flexible tube (L) into the appropriate attachment (A) on the body of the
vacuum and block it by pressing it in until a click is heard (FIG. 4). To remove the tube, press the
button positioned on its extremity and extract it.
To BLOW:
- Insert the extremity of the flexible tube (L) into the appropriate attachment (F) on the cover of the
vacuum and block it by pressing it in until a click is heard (FIG. 5). To remove the tube, press the
button positioned on its extremity and extract it.
ATTACHMENTS
Extension tube (O)
Attach the extension tube to the handgrip and successively install the required accessory.
Once the attachment has been inserted, it is possible to extend the telescopic tube to the required
length with the click lever (FIG. 6). Release the lever to secure the length required.
Floor brush (M)
- Suitable to clean large areas as well as those corners that are hard to reach
- We advise against using the brush on carpets or hard floors. To lift the brush, press the lever (N)
marked with the carpet symbol
- For better cleaning and preservation of smooth flooring, such as PVC, parquet or tiles, it is ad-
visable to use the brush. To remove the brush, press the lever (N) marked with the smooth floor
symbol
Crevice nozzle (P)
This suction device is ideal for cleaning between the folds on fabrics, joints, corners or niches that
are impossible to reach using the floor cleaning device. This attachment can also be fitted directly
to the handle (I).
Small nozzle with brush (Q)
Useful for removing dust from books or delicate items such as picture frames, etc.
This is ideal for cleaning furniture, mattresses, cushions, curtains, etc. It can also be fitted directly
onto the handgrip (I).
Unwind the power cord completely and plug the appliance into the mains socket.
To switch ON the vacuum press the switch (B) positioned on the cover.
In some cases, the appliance may "whistle" when switched on.
This is not a fault and the noise will go away with time.
IMPORTANT: Do not use to clean up large or sharp items from the floor as this could damage the
appliance.
ATTENTION: Immediately switch OFF the vacuum if the air inlets or brushes are obstructed. Before
switching ON again, remove whatever has caused the obstruction.
After using the vacuum
After use, switch off the appliance by pressing the switch (B); unplug it from the mains and wind the
cord either around the appliance or the special cord winder (Fig. 13).
.
.
- 8 -