Specifications; Circular Saw Safety Warnings - Makita 5017RKB Betriebsanleitung

ENGLISH
(Original instructions)
1 Lever
2 Clamping screw
3 Base
4 Hex socket head bolt
(For adjusting riving knife)
5 Riving knife
6 Retracting lever
7 Lock-off button

SPECIFICATIONS

Max. cutting depth
No load speed (min
• Due to our continuing program of research and devel-
opment, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2014
Intended use
The tool is intended for performing lengthways and
crossways straight cuts and mitre cuts with angles in
wood while in firm contact with the workpiece.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
For public low-voltage distribution systems of
between 220 V and 250 V
Switching operations of electric apparatus cause voltage
fluctuations. The operation of this device under unfavour-
able mains conditions can have adverse effects to the
operation of other equipment. With a mains impedance
equal or less than 0.35 Ohms it can be presumed that
there will be no negative effects. The mains socket used
for this device must be protected with a fuse or protective
circuit breaker having slow tripping characteristics.
Explanation of general view
8 Switch trigger
9 Hex wrench
10 Shaft lock
11 Inner flange
12 Saw blade
13 Outer flange
14 Hex socket head bolt
15 Dust cap
Model
Blade diameter
–1
)
Overall length
Net weight
Safety class
at 90°
at 45°
General power tool safety warnings
WARNING: Read all safety warnings, instructions,
illustrations and specifications provided with this
power tool. Failure to follow all instructions listed below
ENE028-1
may result in electric shock, fire and/or serious injury.
Save all warnings and instructions for future refer-
ence.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-operated
ENF002-2
(cordless) power tool.

CIRCULAR SAW SAFETY WARNINGS

Cutting procedures
1. DANGER: Keep hands away from cutting area
and the blade. Keep your second hand on auxil-
ENF100-1
iary handle, or motor housing. If both hands are
holding the saw, they cannot be cut by the blade.
2. Do not reach underneath the workpiece. The
guard cannot protect you from the blade below the
workpiece.
3. Adjust the cutting depth to the thickness of the
workpiece. Less than a full tooth of the blade teeth
should be visible below the workpiece.
4. Never hold the workpiece in your hands or
across your leg while cutting. Secure the work-
piece to a stable platform. It is important to sup-
port the work properly to minimise body exposure,
blade binding, or loss of control. (Fig. 1)
5. Hold the power tool by insulated gripping sur-
faces, when performing an operation where the
cutting tool may contact hidden wiring or its own
cord. Contact with a "live" wire will also make
exposed metal parts of the power tool "live" and
could give the operator an electric shock.
16 Rubber cap
17 Vacuum cleaner
18 Rip fence (Guide rule)
19 Limit mark
20 Brush holder cap
21 Screwdriver
5017RKB
190 mm
66 mm
46 mm
4,800
356 mm
5.5 kg
/II
GEA010-2
GEB143-1
5