Maintenance; Usb Connection; Daily Maintenance - Husqvarna PP 70 Montage- Und Bedienungsanweisung

Status indication lamps
When the product is connected, the lamps 1-5 comes on
for some seconds.
1 2 3
4
Introduction
WARNING: Read and understand the safety
chapter before you do maintenance on the
product.

Daily maintenance

WARNING: Disconnect the product from the
power supply and wait minimum 5 minutes
before you start the maintenance.
CAUTION: Do not use a high pressure
washer to clean the product. The high
pressure can cause damage to the seals
and cause water and dirt to come into the
product.
• Do a check of the safety equipment. Make sure that
it is not damaged. Refer to
product on page 6 .
• Make sure that the power cord and the extension
cable are in good condition and not damaged.
• Make sure that the water hose and water couplings
are in good condition and not damaged.
• Always clean the product at the end of the work day.
Use a heavy duty handheld brush or a large paint
brush.
1244 - 002 -
5

Maintenance

Safety devices on the
1. Phase lamp (green)
2. Phase lamp (green)
3. Phase lamp (green)
4. Service indicator (yellow)
5. Warning indicator (red)
For more information about the status indication lamps,
Explanation of the status indication lamps on
refer to
page 10 .
Warning indicator
CAUTION: Do not continue to operate the
product when the warning indicator is on.
Risk of damage to the product.
If the warning indicator (red lamp) comes on, stop the
Explanation of the status indication
product. Refer to
lamps on page 10 .
• Keep the connectors and pins clean. Clean with a
cloth or brush.
• Make sure that the water system is not damaged.

USB connection

The product has an USB connection.
CAUTION: Only approved brand service
person must use the USB connection.
9