Technical Specifications; Using A Pure Chargepak - PURE Verona Bedienungsanleitung

Technical Specifications

General Stereo digital radio with full Band III and FM reception. ETSI EN 300 401
compliant and capable of decoding all DAB and DAB
up to and including 192 kbps. Supports FM RDS and RadioText.
Frequency ranges DAB Band III 174–240 MHz, FM 87.5–108 MHz.
Speakers Two mid-range 3" drive units.
Inputs 220-240V AC power socket for supplied power cable. 3.5mm Line-in for auxiliary
devices. USB (mini-B type) for software upgrades.
Outputs 3.5mm headphone, 3.5mm line out (analogue).
Presets 50 DAB and 50 FM presets.
Display High contrast yellow graphical 128 x 22 Organic LED (OLED) display
Power cable Detachable mains lead supplied.
Approvals CE marked. Compliant with the EMC and Low Voltage Directives
(2004/108/EC and 2006/95/EC).
Dimensions (mm) 188 high x 280 wide x 100 deep.
Aerial Telescopic aerial attached.
ChargePAK Compatible with PURE ChargePAK E1 (available seperately)
Using a ChargePAK
PURE ChargePAK E1 is a rechargeable battery pack which plugs into the socket in the radio's
battery compartment. Whenever your radio is connected to a mains supply and the power
switch on the rear is switched on, the ChargePAK will be charging and the power remaining will
be available to view as a percentage in the Information display options (> page 5). A complete
charge will provide about 20 hours of portable listening.
To purchase a PURE ChargePAK E1, contact your nearest PURE dealer.
Important: Verona can only be powered with a PURE ChargePAK E1 and is not compatible with
any other batteries, either disposable or rechargeable, or any other ChargePAK model. Always
switch the unit off and disconnect it from mains power before inserting or removing a ChargePAK.
Charge a new ChargePAK for 24 hours before fi rst using battery power. Carefully follow the
separate fi tting instructions that are supplied.
14
+
transmission modes 1-4
+ +
ChargePAK
™