LIVARNOLUX HG02408 Montage-, Bedienungs- Und Sicherheitshinweise Seite 29

Make sure that the LED spotlight
can move the product vertically to adjust the angle.
Make sure the motion sensor
sensor has a maximum coverage range of 8 m, with a coverage
1
angle of about 160 ° (depending on the mounting height – a height
of 1.80–2.50 m is ideal).
Make sure the motion sensor
lighting. This can influence its functioning.
Don't adjust the motion sensor
where animals could be easily detected. Do not adjust the motion
sensor to fan heaters, air conditioners, pools or other objects with
1
fast-changing temperatures.
Use the bracket
wall. Ensure that there are no cables or wires in this area in the wall.
Drill two holes (Ø 8 mm) and insert the wall plugs
bracket with the help of the screws
4
necessary, isolate 6–8 mm from house conductor terminal
nect the outer conductor
tective conductor
junction box (see Fig. C).
Note: The connection cable type should be H05RN-F 3G 1.0 mm².
Note: The protective conductor
than the other conductors, so that it is the last one to tear off in the
event of a breakage of the product.
The used connection terminal must have at least the following specifi-
cations:
Type of connection terminal: With screws
Number of contacts:
Operating voltage:
Rated current:
2
covers the desired area. The motion
1
is not illuminated at night by street
1
1
as a pattern to mark the drilling holes onto the
4
, the neutral conductor
5
to the terminal block
6
3
> 230 V ~
>1 A
illuminates the desired area. You
onto trees, bushes or locations
and check the tight fit. If
25
of a properly installed
24
connection is to be used longer
6
. Screw the
26
. Con-
23
and the pro-
7
GB/IE 29