Getting Started; Cleaning And Care - Klarstein 10034117 Bedienungsanleitung

EN
16

GETTING STARTED

Setting the Temperature Control
The thermostat temperature controller is located on the display on the front touch panel.
• Insert the plug into the mains socket. On the display, all display areas light up for
1 second.
• Use the Plus/Minus button to set the desired temperature. Each time the button
is pressed, the temperature is increased or decreased by 1 °C. The lowest
temperature is 0 °C, the highest 10 °C.
• After you have set the desired temperature, wait for 5 seconds, "SET" appears in
the display.
• When the small thermometer icon appears on the display, the appliance is cooled
down to the set temperature.
• To lock the settings, press and hold the Plus/Minus buttons for 2 seconds, a beep
will sound and the lock indicator will flash. To release the lock, press and hold the
Plus/Minus buttons again for 2 seconds, the lock indicator will turn off.

CLEANING AND CARE

Outside
The outside of your refrigerator can be cleaned using a soft cloth moistened with a
mild detergent solution. Wipe dry with kitchen towel. Do not use chemical or abrasive
cleaners on any part of your refrigerator as these could permanently damage or
discolour the surfaces.
Internal Cleaning
Wipe up any internal spills immediately with a soft cloth moistened with a mild detergent
solution. Dry thoroughly.
Shelves and Guards
Any shelves can be removed and cleaned separately.
Door Seals
Ensure that the door seals are kept free from debris at all times. If they don't seal
properly this can waste energy and cause refrigeration unit to over run.