Turning The Power On; Changing Between Input Terminals [Ll-T17D4]; Turning The Power Off - Sharp LL-T17A4 Bedienungsanleitung

Connecting the monitor and turning the monitor on and off

Turning the power on

1. Turn on the main power of the monitor.
Main power switch
- When switching the main power switch on and
off, always wait for an interval of at least 5
seconds. Rapid switching may result in
malfunction.
2. Press the monitor's power button.
The power LED will light up orange.
3. Turn on the computer.
Press power button.
When a signal is input from the computer, the
power LED lights up green, and the screen is
displayed. (After power is turned on, it may take
a little time until the screen is displayed.)
Note for LL-T17D4:
- If the input terminal to which the computer is
connected has not been selected, the screen
will not be displayed. If necessary, perform input
terminal switching. (right column)
Notes:
- When using an analog signal, perform an
automatic screen adjustment under the following
conditions (p.16):
- Using the monitor for the first time.
- After having changed the system settings
during use.
- Depending on the type of computer or OS, you
may need to install the monitor set-up
information on your system. (p.26)
- When connecting to a notebook, if the notebook
computer's screen is set to display at the same
time, the MS-DOS screen may not be able to
display properly. In this case, change the
settings so that only on the monitor.
Changing between input terminals
[LL-T17D4]
Use the INPUT button to switch between signal
input terminals.
Analog RGB input
The input signal type (ANALOG/DIGITAL) is
displayed within angle brackets < >.
Note:
- When there is no input signal, [NO SIGNAL] is
displayed.

Turning the power off

Turn on the
1. Turn the computer off.
computer power
2. Press the monitor's power button.
supply.
The power LED will disappear.
ON
Turn the computer
off.
If the monitor will not be used for a long time, turn
off the main power switch of the monitor, and
remove the power plug from the outlet.
13
DVI-I input
terminal terminal
INPUT
INPUT-1
<ANALOG>
Press power button.
OFF
INPUT-2
< >