Overview Of The Components; Intended Use; Start-Up Of The Device/Introduction - AEG MC 4432 CD Bedienungsanleitung

English
42

Overview of the Components

1 CD compartment
2 LCD display
3 TUNING control
4  (open/close) CD compartment
5 IR Sensor for the remote control
6 VOLUME +/- (volume) buttons
7 AUX IN connection
8 II (Play/Pause) button
9  (Stop) button
10 Band selection switch (FM ST. / FM / AM)
11 Cassette compartment
12 II Pause button - cassette
13   Stop/Eject button - cassette
14  Forward button - cassette
15  Reverse button - cassette
16  Playback button - cassette
17 FUNCTION Function selector switch
(TAPE/OFF / AUX IN / CD/MP3/USB / RADIO)
18 I button (forward search)
19 I button (reverse search)
20 USB connection
21 MODE button (repeat/random / memory)
22 CD/MP3/USB button
23 BASS BOOST OFF/ON switch
24 POWER control lamp
Reverse Side (not shown)
25 R/L Loudspeaker connections
26 AC Mains connection
27 FM ANT. throw-out aerial
Remote Control
1 FOLDER DOWN /UP  buttons
(down/up album)
2  STOP button
3 SKIP -/+ buttons
(reverse search/forward search)
4 PROG button
5 MODE button (repeat/random)
6 II PLAY/PAUSE button)

Intended Use

This device is used for:
• The reception of radio programmes
• Playing back audio cassettes
• Playing back audio/MP3 CDs
• Sound playback from external audio sources.
It is intended exclusively for this purpose and may only
be used as such. It may only be used in the manner
described in these instructions for use. The device must
not be used for commercial purposes.
Any other use of this device is considered to be contrary
to the intended use and may result in damage to materi-
als or even personal injury.
05-MC 4432 CD.indd 42
The firm ETV – Elektro-Technische Vertriebsgesellschaft
mbH does not accept any liability for damage caused as
a result of the use of this device contrary to its intended
use.

Start-up of the device/Introduction

• Read the operating instructions thoroughly before the
start-up!
• Select an appropriate location for the device, e.g. a
dry, flat, non-slip surface on which the device can be
easily operated.
• Make sure that the device is adequately ventilated!
• Connect the loudspeakers to the back of the music
centre to the sockets market „Speaker R and L" (25).
• Remove the protective film from the display if it is
still present.
Power Supply
• Insert the plug into a properly installed 230 V, 50 Hz
power socket.
• Please ensure that the mains voltage corresponds to
the information on the type plate.
Inserting the Batteries

NOTE:
The lithium cell in the battery compartment of the re-
mote control has been secured for transport with a foil.
This prolongs the lifetime of the battery. Before initial
use please remove this foil so that the remote control is
ready for operation.
The battery of the remote control is a long-life lithium
cell. If the range of the remote control is reduced during
use, please proceed as follows:
• Open the battery compartment on the back of the
remote control.
• Replace the cell by a battery of the same type
(CR 2025). Ensure correct polarity.
• Then close the battery lid.
If the remote control is not used for a prolonged period,
remove the batteries in order to prevent battery acid
leaking.
CAUTION:
Batteries are not to be disposed of together with
domestic wastes. Dispose of the used batteries at the
relevant collection bin or at your dealer's.
WARNING:
• Do not expose the batteries to high temperatures
or direct sunlight. Never throw batteries into the
fire. There is a danger of explosion!
• Keep batteries away from children. They are not a
toy!
• Do not open the batteries by force.
12.03.2010 10:21:58 Uhr