Setting Up The Remote Controlled Socket - Silvercrest 322055 Bedienungs- Und Sicherheitshinweise

replace with the same or equiv-
alent battery type.
1. Open the battery compartment
on the back of the remote control
by turning the battery compart-
ment cover
4
the aid of a coin or a screwdriver,
then removing the lid (open).
2. Replace the button cell type CR
2032. Make sure you fit the
battery with the correct polarity
(+ = up).
3. Place the battery compartment
cover back on and lock it in
4
place by turning it in a clock-
wise direction (close).
4. Press one of the ON / OFF
buttons or
2
the remote control works; if it
does, the power indicator light
will come on
14 GB/IE/NI
anti-clockwise with
to test whether
3
.
1
S etting up the remote
Q
controlled socket
(fig. B)
1. Plug the wireless socket into an
earthed mains socket. You now
have 30 seconds to complete
steps 2 and 3.
Note: Always plug in the wire-
less socket in the direction indi-
cated on the product label to
maintain the splash water protec-
tion (arrow must point up).
Protection against water spray
is only guaranteed when a
socket of the same protection
rating (classification IPX4) is
connected.
2. Point the remote control at the
remote-controlled socket at a
distance of approx. 50 cm.
3. Push the respective ON button
of the Channel ON / OFF