Recovering From Errors - Brady BSP45 Handbuch

ENGLISH

Recovering from Errors

If the machine enters an error state (caused by a missed sleeve or jammed material), the STOP button
flashes red to indicate an error. Once the machine registers an error, the START and STOP buttons are
no longer active until the following procedure is followed.
1. Open the rear door.
2. Open the die module.
3. Address the error.
When the problem has been fixed:
4. Close the die module.
5. Close the rear door.
The buttons are now active and the STOP button is red. Press the START button and follow the IN-
PEDAL-UP procedure to continue the job.
2/25/16
Recovering from Errors 17
BSP45 User's Manual