Functions Description; Installation - Bossini AQUAVOLO RGB Montage- Und Wartungsanleitung

ASSEMBLY INSTRUCTIONS
Introduction
For ideal installation, showerhead must be placed at a height of about 2,000 mm from the floor,
(meaning the distance between the lower part of the showerhead and the shower tray). The
recommended flow rate for good functioning of the showerhead is 14 L per minute. The electrical
supply must be positioned above the water connection.

FUNCTIONS DESCRIPTION :

Aquavolo Chromotherapy, the Bossini high-tech shower with chromotherapy functions, WideRain and
Cascade sprays.
- 3 functions :
• Wide Rain Spray : shower with horizontal body, it delivers a wide rain spray.
• Cascade Spray: pulling the body downwards it delivers a pleasant cascade spray.
• Chromotherapy : the showerhead incorporates 4 Led lights with a range of 7 colours generating a
beneficial chromotherapy effect.
CONTROL KEYBOARD
The control keyboard is watertight, thus can be indifferently positioned inside or outside the shower. This
keyboard controls the chromotherapy functions as follows :
PREPARING THE WALL SUPPORT
- Set the water inlet point at a height of 2,020 mm (Fig. A).
- Arrange for the electrical connection exactly above the water inlet point at 20÷30 mm distance from it,
inserting the three modules box (12) included in the package into the wall (Fig. C).
- Place the wall support (1) to make the three modules box (12) match with the plate opening (Fig. A).
- Fit a three modules box (12) inside the shower at 1,100 mm height for keyboard control housing (Fig.
A – Fig. B).
- Arrange for a junction box sized 190x190x70 mm (not supplied) outside the shower, away from areas 1
and 2 indicated by CEI 64-8/7 regulation, which will house transformer box (14) included in the package,
housing the 7V ~ / 230V ~ – 50/60 Hz transformer, filter included.
Use a corrugated pipe of at least 20 mm diameter (Fig. A) to connect the junction boxes
WARNING!
The control keyboard is supplied with a 3 meter long connecting cable. In case the installation requires a
longer cable, ask for the supply of a control keyboard with the cable of the desired length.

INSTALLATION

-Temporarily fix the wall support plate (1) by screwing the water inlet connector (2) to the water supply
point
(Fig. D).
-Make sure the support plate is perfectly horizontal to the floor using a level. Use a pencil to mark the six
holes for the fastening screws (3). Then remove the water inlet connector (2) and the wall support plate
(1) (Fig. D).
- Drill the six holes using a 8 mm drill bit, and insert the wall plugs. (Fig. E).
- Firmly fix the wall support plate (1) by screwing the water inlet connector (2) and the six screws into the
wall (3) (Fig. F).
-Insert the showerhead (4) and screw the suitable fastening dowels (5) already mounted onto the support
plate. Then fix the open end of the gas springs (9) onto the lower part of the support plate with the suitable
screws (6) (Fig. G).
AQUAVOLO RGB
- One touch activates LED lights with cyclic colour change
- Two touches stop the displayed colour cycle
-Three touches switch the system off
The Time-Out function automatically switches the appliance off after
about 30 minutes, when no command is given to the system.
(Cod. I02555)
GB
22