Technical Specifications; Symbols And Icons; Symbols In The Manual - FLORABEST FRMA 36/1 A1 Originalbetriebsanleitung

GB

Technical specifications

Appliance .........................36/1 A1
Motor voltage ............................ 36 V
Idling speed n ...................... 3100 min
0
Cutting circle ............................ 370 mm
Cut height ......25/35/45/55/65/75 mm
Protection class ....................................III
Protection type .................................IPX1
Weight (without battery
and charger) ............................. 13.2 kg
Grass box volume ............................ 40 l
Sound pressure level
(L ) ........................ 82 dB(A); K
PA
Sound power level (L
measured ....93.9 dB(A); K
guaranteed ........................... 96 dB(A)
Vibration (a ) ......< 2.5 m/s
h
Battery (Li-Ion) ...............PAP 36 A1
Number of battery cells....................... 20
Nominal voltage ........................ 36 V
Capacity ............................... 2600 mAh
Energy .....................................93.6 Wh
Charging time ...................... approx. 1 h
Charger ............................40LFC15
Voltage input ..... 220-240 V~, 50 Hz, 1 A
Voltage output ..................... 40 V
Protection class ...............................
Protection type .................................IPX0
Noise and vibration values have been
determined according to the standards and
regulations mentioned in the declaration of
conformity.
Technical and optical changes may be
undertaken in the course of further develop-
ment without notice. All dimensions, refer-
ences and information in this instruction
manual are therefore not guaranteed. Legal
claims made on the basis of the instruction
manual can therefore not be considered as
valid.
6
= 3 dB
PA
)
WA
= 1.88 dB
WA
; K =1.5 m/s
2
h
The stated vibration emission value was
measured in accordance with a standard
testing procedure and may be used to com-
pare one power tool to another.
The stated vibration emission value may
-1
also be used for a preliminary exposure
assessment.
Warning: The vibration emission
value may differ during actual use
of the power tool from the stated
value depending on the manner in
which the power tool is used.
Safety precautions aimed at protect-
ing the user should be based on
estimated exposure under actual
usage conditions (all parts of the op-
erating cycle are to be considered,
2
including, for example, times during
which the power tool is turned off
and times when the tool is turned on
but is running idle).

Symbols and icons

Symbols in the manual:

Warning symbols with in-
formation on damage and
3 A
injury prevention.
II
Instruction symbols (the instruction
is explained at the place of the ex-
clamation mark) with information on
preventing damage.
Help symbols with information on
improving tool handling.