Troubleshooting - ORFELD X-503 Bedienungsanleitung

5. Troubleshooting

Problems Causes
The X-503's There is something wrong with
movements or the X-503's software.
travel path are
abnormal.
The side The side brushes are mounted
brushes deform in reverse.
when you start
cleaning the
first time.
The X-503 The robot judge by itself that it
doesn't keep has finished all the cleaning
working for work and return for charging.
100 minutes.
The X-503 does
not perform
cleaning work
automatically as
scheduled on
remote control.
The X-503 The side brushes or rolling
suddenly make brush deform.
noise.
Scheduling failed.
The robot was restarted after
scheduled.
17
Solutions
Clean the sensors carefully with
a dry cloth.
Restart the X-503 by turning
the power switch off and back
on.
Please install the side brushes
correctly according to the marks
L and R on the device.
It is normal.
The remote control scheduling
must be in a non-sleep state, and
there is a voice prompt for the
start and success of scheduling.
In addition, the robot needs to
be rescheduled after power off.
Remove the side brushes and the
rolling brush separately to see if
there are still any noise when
working. If yes, confirm the
problem accessory and replace it
with a new one.