Inserting/Replacing Bits; Torque Setting; Handle Setting; Use As A Torch - Parkside PSSA 3.6 D4 Originalbetriebsanleitung

Direction switch may only be acti-
vated at a standstill to prevent dam-
age to the transmission.

Inserting/replacing bits

Prior to commencing any work
on the device, bring the direction
switch (
in order to prevent an accidental
start up.
1. Insert the desired bit (14) or bit
holder (15) into the bit adapter
(11). It locks into place audibly.
2. To remove the bit or bit holder
pull the spring sleeve (1) back.
3. With the spring sleeve (1) pulled
back remove the bit or bit holder
from the bit adapter (11). Release
the spring sleeve.

Torque setting

Always turn off the device, before
setting the torque.
1. Turn the adjusting ring (2) to se-
lect the desired torque:
Step 1 -->
Step MAX -->
Screws:
Drilling:
2. Start with a lower torque step
and increase according to re-
quirement.
The necessary torque is dependent
on:
- the type and hardness of the
material to be treated;
- the type and length of the
screws used.
9) to the neutral position
lowest torque,
highest torque
(5 Nm).
Steps 1 - 6
Step MAX.

Handle setting

Prior to commencing any work on the
device, bring the direction
switch ( 9) to the neutral position in
order to prevent an accidental start up.
The device can be locked in two hand settings:
- Pistol grip position
- Rod position
Press the release key PRESS (4) and
turn the handle (6) of the device by
180°. It locks into place audibly.

Use as a torch

1. Press the torch lens (5) on the
underside of the handle (6). The
torch LEDs light up.
2. To switch off the LEDs press the
torch lens (5) again.

Cleaning/Maintenance

Leave any work not covered in this
manual to our Service Centre. Only use
original parts. There is a risk of injury!

Cleaning

Clean and service the device regularly as fol-
lows. This guarantees a long life for your unit:
Do not jet water onto the ap-
pliance and do not clean it un-
der flowing water. This would
result in the danger of an elec-
tric shock and the appliance
could be damaged.
• Keep the ventilation slits, motor housing
and handles on the equipment clean. To do
this, use a damp cloth or brush.
GB MT
51