General Safety Regulations; Special Safety Regulations - lamber DSP1 Installation Bedienung

INTRODUCTION
AND SAFETY NORMS
INTRODUCTION
- The machine DSP1-2-3-4-5 is an Industrial dishwashers .
- The machine is in conformity to the European Norms 89/336/CEE for the radio noises.
- According to EEC directive nr .23 of 19/02/1973 and the law of ac tuation nr.791 of 18/10/1987, our
appliances are buil-up according to the good technique norms in force in Italy and abroad.
- Noise level of the machine, less than 70 dB(A).
PRELIMINARY OBSERVATION
Carefully read the instructions reported in the present user manual, as it gives important indications
safety of installation, operation and maintenance:
- carefully keep the present manual for further consultations;
- the illustrations and drawings showing the mach ine are intended for general reference only and
not necessarily accurate in every particular;
- the dimensions and characteristics of the machine, given in this Manual, are not to be considered
binding and may be changed without prior notice;
- having removed the packing material, check that all the equipment is present. If there is any doubt, do
not use it and contact qualified personnel. The packi ng elements (plastic bags, nails, etc.) should be
kept away from children, because they are dangerous.

GENERAL SAFETY REGULATIONS

THIS SAFETY CODE HAS BEEN COMPILED IN YOUR
reduce the risks of injury both to yourself and to others;
Personnel working with this machine must adhere strictly to all statutory safety regulations as well as the
specific rules listed below. Failure to do so may result in personal inyury and damage to the machine;
- DO NOT attempt to move, install, set-up or
understood this Manual. If doubt persists, ask your supervisor;
- never leave tools, parts or other loose material on or in the machine;
- Before switching the equipment the equipment on, ma ke sure that the model plate data conforms to
that of the electrical and water distribution network;
- remember that even with the mains isolator in the "OFF" position, the incoming cables are still live;
- BEFORE starting machine o cycle, after any maintenance or repair work, make sure all protective are
correctly installed;
- be vigilant at all times, remember that your safety and that of your fellow workers depend on you;
- when moving or lifting the machine, care must be ta
governing such operations;
- installation should be carried out by qualified personnel according to the manufacturer's instructions.
- this equipment should be destined to the use which it has been conceived for. Any other application
should be considered improper and consequently dangerous;
- the equipment should only be used by personnel trained for its use;

SPECIAL SAFETY REGULATIONS

- adjustement and repairs must be carried out onl
unskilled personnel may be dangerous;
- perfect washing-up results as far
machine can be assured only in case the instruct ions reported in the present handbook are carefully
followed;
- the machine must be only used by authorized personnel which must comply with sanitary measures;
- do not leave the machine in environment with temperatures inferior to 6°C;
the machine protection degree is IP21, therefore it should not be washed with direct high pressure
-
jets of water;
INTEREST. Strict adherence to these rules will
operate this machine until you have read and fully
ken to comply with all the relevant regulations
y by personnel qualified. Repair carried out by
as hygiene concerns and a correct operation of the washing
9
ENGLISH
about
are