Beurer BM 93 Cardio Gebrauchsanleitung Seite 53

Problem /
Error Message
The ECG measurement
flashes on the display.
The ECG measurement
shows EE on the display.
The device will not switch
on.
The cuff does not inflate.
Possible cause
The ECG signal is unstable
or too weak.
- Contact pressure on the
skin is too weak.
- The measurement was
interrupted.
- The sound level was too
high during the measure-
ment.
The batteries are almost
empty.
The batteries are flat.
The batteries have been
inserted incorrectly.
The cuff line is not correctly
inserted into the device.
The cuff is ruptured.
53
Solution
Repeat the measurement as per
the instructions in these Instruc-
tions for use.
Repeat the measurement as
perthe instructions in these
Instructions for use.
Replace the batteries.
Replace the batteries.
Re-insert the batteries, observ-
ing the correct polarity (-/+).
Ensure that the cuff line is cor-
rectly inserted into the device.
Replace the cuff. Contact
Customer Services.