Before First Use; Replacing The Battery; Operation; Weighing - Silvercrest HG00284D Bedienungs- Und Sicherheitshinweise

Clean the contacts on the battery /
rechargeable battery and in the bat-
tery compartment before inserting!
Remove exhausted batteries /
rechargeable batteries from the
product immediately.
Before first use (Fig. C)
Remove all packaging materials from the product.
Turn the product over and place it on a soft under-
lay to avoid scratching the surface. Loosen the
screw located at the cover of the battery compart-
ment on the back of the product.
5
Open the cover of the battery compartment
on the back of the product.
Pull out the insulation strip from the battery
compartment .
5
Close the cover of the battery compartment
and tighten the screw.
Replacing the battery (Fig. C)
Turn the product over and place it on a soft underlay
to avoid scratching the surface. Loosen the screw
located at the cover of the battery compartment
on the back of the product.
Open the cover of the battery compartment
on the back of the product.
Remove the used battery, if present.
Insert a battery type CR2032 in the battery
compartment .
5
Note: Make sure you insert the batteries with the
correct polarity. This is indicated on the cover of
the battery compartment
Close the cover of the battery compartment
and tighten the screw.
5
5
5
5
.
5
5

Operation

Set the product on a solid, level and flat surface to
weigh.

Weighing

Note: Always place the object you wish to weigh
gently onto the weighing surface
ing the glass surface.
Briefly touch the button
the product. The LC display
plays for approx. 3 seconds.
Note: A slight touch of the button
and the button UNIT
product. If there is too much pressure, the
product may cause tilting.
During this time the weighing equipment on the
product is adjusting. Afterwards the numerical
display will read „0". The unit display
8
show the last unit selected.
Note: if an object (e.g. a key) is already on the
weighing surface
1
numerical display
Place the item you wish to weigh onto the product.
The numerical display
the item you are weighing.

Incremental weighing

Touching the button
on will change the numerical display
reading to „0". The „Tare" symbol
Now add another item to weigh onto the product.
The numerical display
the newly added item.
If you remove the item added to the product, the
numerical display
to avoid damag-
1
/ TARE to switch on
3
will show all dis-
2
/ TARE
is sufficient to operate the
4
while switching on, the
will still read „0".
8
will show the weight of
8
/ TARE with the product
3
from the
8
will appear.
9
will show the weight of
8
will again read „0".
8
GB/MT
3
will
7
33