Herunterladen Inhalt Inhalt Diese Seite drucken

Electrical Warnings - IKEA HUTTRA Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für HUTTRA:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

ENGLISH
a heat source and that the four
feet are stable and resting on the
floor, adjusting them as required,
and check that the appliance is
perfectly level using a spirit level.
Wait at least two hours before
switching the appliance on, to
ensure that the refrigerant circuit is
fully efficient.
WARNING: When positioning
the appliance, ensure the supply
cord is not trapped or damaged.
WARNING: To avoid a hazard
due to instability, positioning
or fixing of the appliance must
be done in accordance with the
manufacturer instructions. It's
forbidden to place the refrigerator
in such way that the metal hose
of gas stove, metal gas or water
pipes, or electrical wires are in
contact with the refrigerator back
wall (condenser coil).
To guarantee adequate
ventilation, leave a space on both
sides and above the appliance.
The distance between the rear of
the appliance and the wall behind
the appliance should be 50 mm,
to avoid access to hot surfaces. A
reduction of this space will increase
the Energy consumption of product.
Please remove the power cord from
condenser hook during installation
before connecting product to
power supply.

ELECTRICAL WARNINGS

It must be possible to disconnect
the appliance from the power
supply by unplugging it if plug is
accessible, or by a multi-pole switch
installed upstream of the socket
in accordance with the wiring
rules and the appliance must be
earthed in conformity with national
electrical safety standards.
Do not use extension leads,
multiple sockets or adapters.
The electrical components must
not be accessible to the user
after installation. Do not use the
appliance when you are wet or
barefoot. Do not operate this
appliance if it has a damaged
power cable or plug, if it is not
working properly, or if it has been
damaged or dropped.
If the supply cord is damaged, it
must be replaced with an identical
one by the manufacturer, its service
agent or similarly qualified persons
in order to avoid a hazard - risk of
electric shock.
WARNING: Do not locate
multiple portable socket-outlets or
portable power supplies at the rear
of the appliance.
Feets of the product: in Fs not
available;in built in - the "feet are
not adjustable - and the METOD
cabinet should be levelled with
spirit level.
9

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis