Instruction Manual; Intended Use - Makita GN420C Bedienungsanleitung

ENGLISH (Original instructions)
SPECIFICATIONS
Dimensions (L X W X H)
Nail length X Shank diameter
Rated voltage
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications and battery cartridge may differ from country to country.
Symbols
The following show the symbols used for the equip-
ment. Be sure that you understand their meaning before
use.
Read instruction manual.
Container under pressure, keep away
from temperatures over 50°C (for ex. sun
radiation) Keep container in a well venti-
lated place.
Use only outside or well ventilated rooms.
Do not breathe gas.
Do not use near flames or sprays on
heated surfaces. In use, may form flamma-
ble/explosive vapour-air mixture.
Do not damage, puncture or burn even
after use.
Wear safety glasses.
Wear ear protection.
Keep fingers away from trigger when not
driving fasteners to avoid accidental firing.
Use only in ventilated area to avoid nausea
and unconsciousness. Never use tool
in combustible atmospheres. The tool
exhaust may ignite flammable materials.
Do not use on scaffoldings, ladders.
Warning: hot surface!
Do not touch around this symbol. Touching
the surface may cause burns or injuries.
Model
Nail capacity
Net weight
20 nails (2strips)
315 mm X 108 mm X 390 mm
3.6 kg
Nail L :15 mm - 40 mm d : 2.6 mm - 3.1 mm
Only for EU countries
Ni-MH
Do not dispose of electric equipment or battery
Li-ion
pack together with household waste material!
In observance of the European Directives,
on Waste Electric and Electronic Equipment
and Batteries and Accumulators and Waste
Batteries and Accumulators and their imple-
mentation in accordance with national laws,
electric equipment and batteries and battery
pack(s) that have reached the end of their life
must be collected separately and returned to an
environmentally compatible recycling facility.

Intended use

The tool is intended for securing a thin steel plate to the
concrete.
Noise
The typical A-weighted noise level determined accord-
ing to EN ISO 11148-13:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB (A)
Wear ear protection
Vibration
The vibration total value determined according to EN
ISO 11148-13:
Vibration emission (a
Uncertainty (K) : 1.5 m/s
NOTE: The declared vibration emission value has been
measured in accordance with the standard test method
and may be used for comparing one tool with another.
NOTE: The declared vibration emission value may
also be used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual
use of the power tool can differ from the declared emission
value depending on the ways in which the tool is used.
WARNING:
Be sure to identify safety measures to pro-
tect the operator that are based on an estimation of exposure
in the actual conditions of use (taking account of all parts of the
operating cycle such as the times when the tool is switched off
and when it is running idle in addition to the trigger time).
6 ENGLISH
GN420C
40 nails (4strips)
430 mm X 108 mm X 390 mm
3.8 kg
D.C. 7.2 V
) : 96 dB (A)
pA
) : 100 dB (A)
WA
2
) : 3.5 m/s
h
2