WolfVision VZ-8light4 Bedienungsanleitung Seite 8

Shooting Area on the Working Surface
Shooting Area Outside of the Working Surface
Close-up adaptor lens
For shooting an object outside of the working surface, the close up lens (#6) has to be flipped open. It is
impossible to remove the lens completely from the unit and therefore it cannot get lost.
When using the Visualizer to again record on the working surface, put the close up lens back to its original
position.
The camera can be tilted by 220° (120° to the speaker and 100° to the audience).
∞
Eliminating reflections
In order to eliminate reflections (on high gloss photographs etc.) just
move the recorded object or document and rotate the camera head to
center the desired pick-up area. It is also possible to turn the camera
arm with the light downwards and rotate the camera head to the center
of the desired pick-up area to eliminate reflections.
The curvature of the working plate is specially designed to eliminate
reflections.
Please note that reflections can also be caused by general room
lighting conditions.
Turning the camera arm downwards
In order to enable recordings with illumination outside of the working
surface, the camera arm of the Visualizer together with the light source
can be turned vertically down.
Image Flip
∞
By turning the camera head to record in front of the Visualizer, the
image will be automatically turned 180 degrees ("image flip"). This
feature is very useful for recording the face of the presenter or objects
hanging on the wall behind the unit.
7