Technical Data; Environment Concerns - Zanussi zdt431 Benutzerinformation

The dishes are not clean
Limescales particles on the dishes • The salt container is empty.
The dishes are wet and dull
There are streaks, milky spots or
a bluish coating on glasses and
dishes
Dry water drop signs on glasses
and dishes

Technical data

Dimensions
Electrical connection - Voltage -
Overall power - Fuse
Water supply pressure
Capacity

Environment concerns

The symbol on the product or on its packaging
indicates that this product may not be treated as
household waste. Instead it should be taken to the
appropriate collection point for the recycling of electrical
and electronic equipment. By ensuring this product is
disposed of correctly, you will help prevent potential
negative consequences for the environment and human
health, which could otherwise be caused by inappropriate
waste handling of this product. For more detailed
information about recycling of this product, please
32
The cleaning results are not satisfactory
• The selected washing programme is not applicable for the type of load and
soil.
• The baskets are loaded incorrectly so that water cannot reach all surfaces.
• Spray arms do not turn freely because of incorrect arrangement of the load.
• The filters are dirty or not correctly installed.
• The quantity of detergent is too little or missing.
• The water softener is adjusted on a wrong level.
• The salt container cap is not closed correctly.
• No rinse aid has been used.
• The rinse aid dispenser is empty.
• Decrease the rinse aid dosage.
• Increase rinse aid dosage.
• The detergent can be the cause.
Width
Height
Depth
Information on the electrical connection is given on the rating plate on the
inner edge of the dishwasher door.
Minimum
Maximum
59,6 cm
81,8-87,8 cm
55,5 cm
0,05 MPa (0,5 bar)
0,8 MPa (8 bar)
12 place settings
contact your local council, your household waste disposal
service or the shop where you purchased the product.
The packaging materials are environmentally friendly and
can be recycled. The plastic components are identified by
markings, e.g. >PE<, >PS<, etc. Discard the packaging
materials in the applicable container at the community
waste disposal facilities.