Safety; Intended Use - WIKA P-3x Betriebsanleitung

2. Safety

2. Safety
WARNING!
EN
Before installation, commissioning and operation, ensure that the appropriate pressure
sensor has been selected in terms of measuring range, design and specific measuring
conditions. Non-observance can result in serious injury and/or damage to the equipment.
WARNING!
■
■
■
■
■
Further important safety instructions can be found in the individual chapters of these
operating instructions.

2.1 Intended use

The pressure sensor is used to convert pressure into an electrical signal.
The pressure sensor has been designed and built solely for the intended use described here and may
only be used accordingly.
This is class B equipment for emissions and is intended for use in industrial environments. In other
environments, e.g. residential or commercial installations, it can intefere with other equipment under
certain conditions. In such circumstances the operator is expected to take the appropriate measures.
The technical specifications contained in these operating instructions must be observed. Improper
handling or operation of the pressure sensor outside of its technical specifications requires the
instrument to be taken out of service immediately and inspected by an authorised WIKA service
engineer.
The manufacturer shall not be liable for claims of any type based on operation contrary to the intended use.
6
Open the connections only after the system has been depressurised.
Prior to opening the instrument, disconnect it from the mains.
Always operate the pressure sensor within the overpressure limit.
Observe the working conditions in accordance with chapter 3 "Specifications".
For the application of the pressure sensor in connection with aggressive/corrosive media
and for avoiding mechanical damages, see chapter 3 „Specifications".
WIKA operating instructions pressure transmitter, model P-3x