Periods Of Inactivity; Scrapping - IPC PW-C50 Royal-C Bedienungsanleitung

Vorschau ausblenden

Inhalt

Inhaltsverzeichnis

Verfügbare Sprachen

CHANGING THE HIGH PRESSURE NOZZLE

Information

The high pressure nozzle fitted on the lance must be changed

from time to time, as this component is subject to normal wear

during use. Wear may generally be detected by a drop in the

working pressure of the cleaner. To replace it, consult your

supplier and/or dealer for instructions.

TABLE OF ROUTINE MAINTENANCE TO BE PER-

FORMED BY THE USER.

Description of operations:

Check power cable - pipes - high pressure

connectors

Ist oil change in H.P. pump

Subsequent changes in H.P. pump

Clean water filter

These intervals refer to normal working conditions. For heavy duty use decrease the interval for each job.

For maintenance and/or repairs, use only original spare parts which offer the greatest characteristics of quality and

reliability. Failure to use original spare parts absolves the manufacturer from all liability and transfers it to the per-

If the machine is to remain inactive for a long period, disconnect the supply sources, drain the tank(s) of all the operating fluids

and protect any parts that could be damaged by the accumulation of dust.

Grease the parts that could be damaged by drying out, such as the supply hoses. When bringing back into use, ensure that

there are no cracks or cuts in the water supply hoses.

Oil and chemical products must be disposed of according to current legislation.

If you no longer wish to use the water cleaner, you should render it unusable by removing the power cable.

You should also make sure that all potentially hazardous parts of the appliance are made safe, particularly for children who could

play with the unused water cleaner.

This product is classified as WEEE type special waste and is covered by the requisites of the new environmental protection

regulations. It must be disposed of separately from ordinary waste in compliance with current legislation and standards.

Do not use parts dismantled for scrap as spare parts.

English

TABLE OF EXTRAORDINARY MAINTENANCE TO

BE PERFORMED BY THE TECHNICAL SERVICE

CENTRE.

Description of operations:

Each use

Change seals on H.P. pump

Change lanze nozzle

Calibrate and check the safety devices

After 50 hours

Every 500 hours

Every 50 hours

IMPORTANT:

son carrying out the operation.