Autoadapt Turny Low Vehicle Installationsanleitung Seite 30

30
Turny Low Vehicle Getting seated
11. Program Turny Low Vehicle
11.1
Activate the programming menu
Hold down the yellow button until
the Enter Code screen is shown. Then
enter the code 1, 2, 3, 4
11.2
Programme movement paths
Turny Low Vehicle has three motors, one each for lengthwise, swivel and extension.
These motors must be programmed to create two separate movement paths for the
seat – comfort and swivel out.
The movement path "comfort" is the lengthwise path that the seat follows when the car
door is closed. The swivel out movement path combines the swivel and extension paths
the seat follows when the car door is open. The programmed path can vary by +/- 5 mm.
Programme with an approx. 15 mm margin to prevent damage to the product and car.
Program the path as close to the B pillar as possible. For many rea-
sons it is a good idea to program as few operations as possible. Use
Stepless Swivel Out first to achieve a smooth, speedy movement path.
When first programming it can be difficult to achieve the optimal
path. There is therefore the ability to save programming at any time
and then directly go into editing mode to do any fine tuning required.
Programme movement path, comfort
1
2
Press 2 for forwards until the screen 2 comes up.
Press 4 for Backwards until the screen 3 comes up.
B pillar