Carlson 1210 Bedienungsanleitung Seite 3

ENGLISH
Assembling and Installing Your Gate:
Step 1.
Determine the width of your doorway or opening.
For openings between 34" and 39":
Remove and discard the protective end screws located at points
X and Y in Diagram A, then skip to Step 3.
For openings between 49" - 59" :
Proceed to Step 2.
Step 2.
Use the 4 Double Ended Screws to fasten the Extension Panel to the Main
Gate Panel so that the new gate configuration fits within your doorway or
opening with 1"- 5" of extra space.
NOTE: You must use 2 sets of Double Ended Screws on top, and 2 sets of
Double Ended Screws on the bottom. See Diagram A.
Diagram A
3
Step 3.
Screw in the 4 Threaded Rods into the 4 corners of the assembled gate.
The Threaded Rods do not need to be fully screwed in, final adjustments
will be made before completing installation.
Step 4.
Use the Paper Wall Mounting Template to help you mark the exact
locations to attache the Maxi Mounting Brackets
To use the Paper Wall Mounting Template, place it against the wall with the
bottom edge of the template touching the floor. You may choose to use a
level or measuring device to ensure exact placement.
Mark the location of the screw
holes of the Mounting Brackets
through the template and onto
the wall. Then, repeat the
process on the opposing side
of the opening or doorway.
ENGLISH
Diagram B
Screw Holes
Diagram C
4