Receive; User Mode; Function - EuroLite PMC-16 MOVE Bedienungsanleitung

Receive

DMX address setting
With the function "Set Address", you can adjust the desired DMX-address via the Control Board.

User mode

DMX Channel mode/ user-defined channel mode
With the function "User Mode", you can set the DMX channel Mode and the user defined channel orders.
Edit user-defined channel mode
With the function "Edit A - C", you can save the user-defined channel mode.

Function

Status
No DMX status
With the function "No DMX status", you can set different modes if there is no DMX-signal.
Close
With this function, you can close the shutter and set the device to center position if there is no DMX-signal.
This mode equals the settings Auto = OFF and Sound = OFF.
Hold
With this function, the device remains in the last received DMX-program if there is no DMX-signal.
Auto
With the function "Auto", you can set the device to auto run if there is no DMX-signal.
Music
With the function "Music", you can set the device to sound-controlled program-run if there is no DMX-signal.
PAN invert
With this function you can reverse the Pan-movement.
TILT invert
With this function you can reverse the Tilt-movement.
PAN degree - Select PAN-angle 630° or 540°
With the function "PAN degree", you can select the PAN-angle.
Automatic Pan / Tilt correction
With the function "Feedback", the PAN and TILT movement can be corrected automatically to the target
position.
Adjust PAN/TILT speed
With the function "Move. spd", you can define the PAN/TILT speed. You can select one of 4 different
modes.
Mic sensitivity
With the function "Mic. sens", you can select the desired microphone sensitivity between 0 % and 99 %.
Dormancy - power standby mode
With the function "Dormancy", you can put the device in the power standby mode. This function will be
automatically activated after a predefined period of time of no DMX activity. In standby mode the lamp/LEDs
and all motors will power down if no DMX signal is sent to the fixture for a period of e. g. 15 minutes (can be
user defined). The fixture will automatically reset and return to normal operation once a DMX signal is sent.
00092402.DOC, Version 1.1
42/55