MO-EL SHARKLITE Gebrauch Und Wartung Seite 11

as indicated on the device.
9. Do not use in presence of gas, inflammable or explosive liquids or
substances.
10. Some fundamental rules which apply to all electrical devices
must be observed when using the heater:
• Do not touch the heather with wet hands.
• Do not handle with bare feet.
• Do not pull the electric cord or the device itself to unplug it
from the socket; pull the plug directly.
11. Avoid the use of an extension cord with this product, because
the extension cord may overheat and cause a risk of fire.
12. Do not apply any modification to the product that could compro-
mise the safety.
13. Keep connections dry.
14. If the power supply cord is damaged, avoid to use the appliance.
For power cord replacing, please contact the manufacturer or the
technical service or a person with similar qualification, in order to
avoid any risk.
15. If the appliance is not used for a long period, disconnect it from
the power supply.
16. Always unplug the appliance before doing any maintenance op-
eration.
CAUTION - Some parts of this product can become very hot and
cause burns. Particular attention has to be given where children
and vulnerable people are present.
2. ELECTRICAL INSTALLATION
The installation should always be carried out by a qualified electri-
cian or a competent person in accordance with the current electrical
standards:
HD 384 CENELEC for Mainland Europe, IEC 60446 and BS 7671
for the United Kingdom, IEC 60445(2010) & ET101:2008 for Ire-
land, AS/NZS 3000 (Australian wiring rules) and IEC 60364-7-708
1988 Internationally and according to the UE 2015/1188 standards.
The energy supply must be done through a properly grounded sock-
et. An overvoltage category III Combined Circuit breaker and Re-
sidual Current Device (RCD) with rated earth leakage operation not
exceeding 30mA must be fitted upstream on the supply line.
11