Using The Resolv 120A With The Samson Dms80 Monitor System; Using The Dms80'S Sub Out - Samson Resolv 120A Bedienungsanleitung

Using the RESOLV 120a with the Samson DMS80 Monitor System

Using The DMS80's SUB OUT

The RESOLV 120a is a great add on to your DMS monitor system providing extended low frequency output. There are sev-
eral ways you can interface your new subwoofer to the DMS80, including using the DMS80's mono SUB OUT, or by using
the DMS 80's LINE OUTs. The following examples outline the connections and operation for the RESOLV 120a working
with the DMS80 system.
– +
INPUT
• Make the connections between your mixer and your DMS80 monitor system as described in the DMS80's users man-
ual and make sure that you turn your mixer all the way down.
• Connect the SUBWOOFER OUTPUT located on the rear panel of the DMS80 to the RIGHT PREAMP INPUT on the
RESOLV 120a.
• Set the RESOLV 120a's Volume control to about 6, and since the DMS80's SUBWOOFER OUTPUT is High-passed at 100
Hz, set the SWEEP control to 180Hz.
• Now run some audio, like music on a CD, through your mixer and raise the level that controls the output connected
to the DMS80 monitor system until you reach a comfortable listening level.
• Now slowly raise the SUBWOOFER LEVEL control located on the DMS80 front control panel and adjust the low fre-
quency output to your taste. You can experiment with the balance between the RESOLV 120a and the DMS satellite
speakers by adjusting the SUBWOOFER LEVEL control. Once you find the balance you like, the RESOLV 120a will track
the satellites when you raise or lower your mixer's output.
Connecting the RESOLV 120a
+
–
LINE IN AUX IN LINE OUT
SPEAKER OUTPUTS SPEAKER IMPEDANCE 4-8
LEFT RIGHT LEFT RIGHT LEFT
LEFT+ LEFT- RIGHT- RIGHT+
SAMSON
DESKTOP MONITOR SYSTEM STEREO 40W X2 MODEL:DA80
10 Inch Long Throw Transducer
17
SUB OUT
RIGHT MONO RISK OF ELECTRIC SHOCK
DO NOT OPEN
WARNING
DO NOT EXPOSE THIS EQUIPMENT
TO RAIN OR MOISTURE AVIS
RISQUE DE CHOC ELECTRONIQUE
NE PAS OUVRIR
CAUTION
FOR CONTINUED PROTECTION AGAINST RISK
OF FIRE, REPLACE ONLY WITH SAME TYPE FUSE ATTENTION
UTILISER UN FUSIBLE DE
RECHANGE DE MÊME TYPE
SERIAL
–
NUMBER
MADE IN CHINA
+
120 Watt Amplifier
– +
INPUT