TR120 Touch Screen Wall Modules
PRODUCT DESCRIPTION
The TR120 wall modules are touchscreen wall modules
compatible with Spyder, Stryker, Lynx, and CIPer Model 30
controllers. See "Compatibility" on page 3 for more
information. The wall module communicates and is
powered by the Sylk bus, so no additional wiring is needed.
It contains integral temperature and humidity sensors
(depending on model) to control comfort. The device
enables local controller configuration through an easy-to-
use touch screen interface with menu driven selections.
Dimensions
The TR120 consists of a back plate and a front cover which
contains a circuit board.
INSTALLATION INSTRUCTIONS
4-49/64
(121)
Fig. 1. Dimensions in in. (mm).
INSTALLATION
1. Read these instructions carefully. Failure to follow
them could damage the product or cause a
hazardous condition.
2. Check ratings given in instructions and on the
product to ensure the product is suitable for the
application.
3. Installer must be a trained, experienced service
technician.
4. After installation is complete, check out product
operation as provided in these instructions.
MOUNTING
Mount the wall module on an inside wall approximately 48
in (1.2m) from the floor (or in the specified location) to
allow for exposure to the average zone temperature. Do
not mount the device on an outside wall, on a wall
containing water pipes or near air ducts. Avoid locations
that are exposed to discharge air from registers or
radiation from appliances, lights or the sun.
53/64
(21)
3-5/16
(84)
M36282
31-00275M-01