Troubleshooting - PiC indolor CLASSIC check Gebrauchsanleitung

Troubleshooting

If any abnormality should arise during use, please check the following points.
to check
No display when the ON/OFF/
START key is pressed
EE mark shown on display or the
blood pressure value is displayed
excessively low (high)
e before
Note:
1. If the unit still does not work, return it to your dealer. Under no circumstance should you disassemble
and repair the unit by yourself.
2. For a guide to the error messages that appear on the display see the instructions on page 16.
Avvertenze
1. Check that the device is intact before using
2. The unit contains high-precision components. Therefore, avoid extreme temperatures, humidity, and
direct sunlight. Avoid dropping or shaking the main unit, and protect it from dust.
3. Clean the blood pressure monitor body and the cuff carefully with a slightly damp, soft cloth. Do not press. Do not
wash the cuff or use chemical cleaner on it. Never use thinner, alcohol or petrol (gasoline) as cleaner.
4. Leaky batteries can damage the unit. Remove the batteries when the unit is not used for a long time.
5. Keep out of reach of children
6. If the unit is stored near freezing, allow it to return to room temperature before use.
7. This unit is not field serviceable. You should not use any tool to open the device nor should you attempt
to adjust anything inside the device. If you have any problems, please contact the store or the doctor
from whom you purchase this unit.
8. For users diagnosed with common arrhythmia (atrial or ventricular premature beats or atrial fibrillation),
diabetes, poor circulation of blood, kidney problems, or for users suffered from stroke or for unconscious
users, the device, as all automatic blood pressure monitors, may have difficulty in determining the proper
blood pressure. These users have to consult with their doctor regularly
9. In diabetic patients with general arteriosclerosis the oscillometric measurement is negatively affected by
the hardening of the artery. So in these cases, auscultation results are more precise.
10. To stop the measurement at any time, press one of the buttons under the display. The cuff will
quickly deflate.
11. Once the inflation reaches 300 mmHg, the unit will start deflating rapidly for safety reasons.
12. Please note that this is a home healthcare product only and it is not intended to serve as a substitute
for the advice of a doctor or medical professional.
13. Do not use this device for diagnosis or treatment of any health problem or disease. Measurement
results are for reference only. Consult a healthcare professional for interpretation of pressure measure-
ments. Contact your doctor if you have or suspect any medical problem. Do not change your medica-
tions without the advice of your doctor or healthcare professional.
Symptoms
Have the batteries run down?
Are the batteries positioned the
wrong way round?
Is the cuff placed correctly?
Did you talk or move?
Was the cuff shaken when
measuring?
Check Points
Replace them with two new
alkaline batteries.
Re-insert the batteries in the
correct positions.
Wrap the cuff properly so that it is
positioned correctly.
Measure it again, staying still.
Keep the wrist steady during
measurement.
21
Correction