Device Parameters Page; Device Statistics Page; Network Configuration Page - Videotec MAXIMUS MVXHD Bedienungslanleitung

5.3.3 Device Parameters page

It is possible to view the product code and other
additional information in the Device Settings menu.
Fig. 19

5.3.4 Device Statistics page

From menu entry Device Statistics all of the statistics
are gathered during device operation are provided in
read-only mode.
Fig. 20

5.3.5 Network Configuration page

From menu entry Network Configuration it is possible
to change the setting of the device. It is possible
to decide whether the device requires an address
assigned statically, dynamically with DHCP or self-
generated. The device supports the Internet Protocol
(IP) in version 4 and 6.
From the same page it is possible to configure 2 DNS
and decide which mechanisms must be enabled
to automatically identify the devices in the local
network.
During configuration it is only possible to select dual
IPv4/IPv6 and it compulsory to enter all the settings
(also for IPv6).
MNVCMVXHDCAM_1545_EN
If the obtain DNS server address automatically is
disabled, it is still necessary to enter a value for the
primary and secondary DSN (e.g.: 8.8.8.8).
Fig. 21
NTP Server: It is also possible to specify if the device
needs to be synchronised with an external NTP
(Network Time Protocol) server.
• DISABLED: Select this option if you do not wish to
synchronise date and time of the device.
• STATIC: Select this option if you wish to
synchronise date and time of the device with those
of the NTP server specified by the static address.
In order for the device to operate correctly,
it is necessary to synchronise it with the
VMS software using a NTP server.
The device is not fitted with a buffer battery
to maintain the date and time. If the device
is switched off, the values must be entered
again.
13