Getting Started - INFICON TEK-Mate Bedienungsanleitung

Getting Started

1. Install the batteries. See
2. Install the sensor. See
NOTE: Installation of the batteries and sensor is required before use.
3. Press the control button to power on the TEK-Mate.
4. Wait for the TEK-Mate to warm up. All three LEDs will illuminate during warm
up. When the High sensitivity LED starts flashing and you hear beeping at a rate
of about one beep per second, the TEK-Mate is ready to find leaks.
The INFICON TEK-Mate Refrigerant Leak Detector provides similar responses to
all CFC's, HCFC's, HFC's and refrigerant blends (e.g. R-410A, R407c) as well as
SF6.
How To Install The Alkaline Batteries
1. Remove the battery cover by releasing the latch and sliding the cover down and
off the handle. You may need a screwdriver or similar tool to do this.
2. Install two "D" size alkaline batteries as shown in
3. Reinstall the battery cover by aligning it with the handle and sliding it up until
the latch engages.
When the batteries reach the end of their life, the green Low Battery LED will start
flashing. While the batteries may operate the TEK-Mate up to one hour after the
Low Battery LED starts flashing, the batteries should be replaced as quickly as
possible.
Figure 1. Properly Installed Alkaline Batteries
- +
+
How To Install The Alkaline
How To Install Or Change the
-
4
Batteries.
Sensor.
Figure 1.