Safety Instructions; User Manual - Toolland TL73104 Bedienungsanleitung

1. Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could
harm the environment. Do not dispose of the unit (or batteries) as unsorted municipal waste; it should
be taken to a specialized company for recycling. This device should be returned to your distributor or
to a local recycling service. Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for choosing Toolland. Please read the manual thoroughly before bringing this device into service. If
the device was damaged in transit, do not install or use it and contact your dealer.
2.

Safety Instructions

Always wear protective gloves.
Warning: risk of property damage or bodily injury.
 Always respect the safety instructions.
 All persons not involved in the loading process must stand clear of the loading ramp.
 Avoid working alone. If an accident happens, an assistant can bring help.
 Keep work area well lighted.
 Dress properly. Do not wear loose clothing or jewellery as they can be caught in moving parts. Protective,
electrically non conductive clothes and non skid footwear are recommended when working. Wear restrictive
hair covering to contain long hair.
 Use eye and ear protection.
 Keep proper footing and balance at all times.
 Wear security gloves and shoes when handling the ramps.
 Only use the device for its intended purpose. Using the device in an unauthorised way will void the
warranty. Do not exceed the maximum capacity.
 Always be careful. Do not use the ramp if you are tired.
 Check the ramp for stress fractures and breakage before every use. All damaged
 Damaged parts must be replaced by a qualified technician.
 Only use original spare parts to replace parts or accessories. Using other parts will void the warranty. Only
use spare parts that are meant to be used with this device.
 For your own safety, have the device maintained by a qualified technician.
 All loading and unloading must be done on a flat, level, dry surface. Make sure the flange faces down and
the tongue edge fully contacts the tailgate or bed of vehicle.
 Make sure the ramp is clean of dirt, debris, grease and oil.
 Make sure all parts are included in the package when unpacking.
3. Assembly
Make sure the flange faces with the tongue down. It is designed to keep the ramp from moving once the weight
of the load is on the ramp.
Line up the holes on the tongue with the holes on the ramp. Insert the bolts from the top and secure with
washers and nuts.
4. Use
 Make sure no persons or animals are under the ramp or truck bed during the loading process.
 Never load a vehicle while its engine is running. Let the vehicle cool down before loading it.
V. 02 – 18/07/2017
TL73104

USER MANUAL

3 ©Velleman nv