Operation - Enerpac WalkPac Bedienungsanleitung

OPERATION

Oil Level
Check the oil before operating the pump. If oil level is low, add oil until oil level
reaches the lip in the neck of the fill port.
Venting
Venting is provided automatically through the vent/fill cap, which also protects against
reservoir over-pressurization.
Indicator Light
Illustration 4 shows the position of the indicator light (F). The light informs the operator
when the battery is depleted and when the motor has failed to operate.
When the battery needs recharging, the indicator light flashes, and will continue to flash
until the battery has been removed.
If the motor does not operate, the indicator fault light will go on and remain on as long
as the pressure pushbutton remains pressed. See the Troubleshooting table on page 7 if
the motor fails to operate.
With Manual Release Valve (See Illustration 5)
1.
2.
3.
4.
With Dump Valve
1.
2.
F
Close the release valve by turning the knob
clockwise.
To advance the tool, activate the pump motor
by pressing the pushbutton.
Releasing the button stops the motor.
To release system pressure, slowly turn the
release valve counterclockwise.
To advance the tool, activate the motor by pressing the pushbutton.
Releasing the pushbutton stops the pump and releases system pressure, retracting the
tool.
PRESSURE
Illustration 4
1
4
5
RELEASE
2
Illustration 5