Night Mode; Overheat Cut-Out; After-Sales Service - EWT PF320LCD Anleitung

The temperature can be set from 5
will be shown on the display. When the temperature
is reached the heater will automatically switch into
stand-by. If the ambient temperature drops the heater
will come on again automatically. Note the electronic
climate control device conserves energy and assists
with temperature regulation e.g. if the heater is set to
HIGH heat and the temperature i`s set to 28
the heater will switch to LOW heat. Then at 28
heater will switch into stand-by.
An audible beep can be heard when any button is
pressed.
A double beep can be heard when 5° and 35° is
selected; the upper and lower limits.
By keeping buttons '3' and '4' pressed down the user
can scroll quickly to the desired temperature.
Note: The heater retains it's last setting once the
appliance has been switched into "STAND-BY" or
disconnected from the power supply.

Night Mode

To activate "Night Mode" press and hold the 'STAND-
BY' button for 5 seconds - see '1' in Fig. 4. The LED
ring will then turn off, and the screen backlight blinks
on/off. After 10 seconds the screen backlight will turn
off. For any subsequent button presses the screen
backlight will light up then turn off again 10 seconds
after last button press.

Overheat cut-out

The built-in overheat cut-out switches off the appliance
automatically in the event of a fault. Disconnect the
mains plug from the socket. After a short cooling down
phase, the appliance switches into stand-by mode and
is ready for use again. If the fault should occur again,
follow the after sales advice.
Fuselink
A thermal fuse link is provided as an added safety
feature. If the fuse link operates and opens circuit it is
the result of abnormal overheating within the appliance
and servicing of the appliance by a competent service
engineer will be required in order to ensure the future
safe operation of the heater.
Cleaning
WARNING : Always disconnect from power supply
before cleaning heater.
Do not use detergents, abrasive cleaning powders or
polish of any kind on the heater.
Wipe with a dry cloth to remove dust and a damp cloth
(not wet) to clean off stains. Be careful not to allow
moisture into the heater.
Ensure that dust or fluff does not accumulate inside
the heater as this could lead to overheating of the
element. Use a vacuum cleaner to remove any fluff
which does accumulate.
C to 35 C and this
o o
C, at 27 C
o o
C the
o
Recycling
For electrical products sold within the European
Community.
At the end of the electrical products useful
life it should not be disposed of with
household waste. Please recycle where
facilities exist. Check with your Local
Authority or retailer for recycling advice
in your country.
After Sales Service
Your product is guaranteed for two years from the
date of purchase.
Should you require after sales service, please contact
the retailer from whom the appliance was purchased
or contact the service number relevant to your country
on the warranty card.
Please do not return a faulty product to us in the first
instance as this may result in loss or damage and delay
in providing you with a satisfactory service.
Please retain your receipt as proof of purchase.
Model Identifier(s):
Heat output
Nominal heat output
Minimum heat output (indicative)
Maximum continuous heat output
Auxiliary electricity Consumption
At nominal heat output
At minimum heat output
In standby mode
Type of heat output/ room temperature control
Electronic room temperature control
Contact details
PF320LCD
Pnom 2.0
Pmin 0.8
Pmax,c 2.0
elmax 0.0
elmin 0.0
elSB 0.0004
GDHVI
Millbrook House, Grange Drive, Hedge
End, Southampton.
SO30 2DF
kW
kW
kW
kW
kW
kW
Yes