Start-Up; Setting The Sensitivity Of The Sensor - Powerfix Profi Z31712A Bedienungs- Und Sicherheitshinweise

Remove the screws
Insert the cable through the cable opening of the base plate
Screw the base plate
Connect the cable to the screw terminal
depicted in Ill. C.
Attach the cover of the connection area back to the base plate
screwing the screws

Start-up

Turn the electricity back on. The device is now ready for use.
Setting the sensitivity of the sensor (Ill. D)
Only models Z31712C/D
Note: the sensor range is max. 12 m (depending on the surrounding
temperature).
Turn the control knob SENS
the sensor range
Turn the control knob SENS
increase the sensor range
from the front of the motion detector (see Ill. B).
2
to the desired position.
4
.
2
in the direction „-" in order to reduce
8
.
1
in the direction „+" in order to
8
.
1
of the motion detector as
3
.
4
by
4
GB/IE 11